Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to make WLC 5508-HA controller mantainance mode to HA mode

Hi,

I have two wlc 5508 with HA mode, If unfortunally redudndent link disconnected and standby wlc goes to mantainance mode.

then again I connected redundent link but second wlc does not come in ha, it still remain in mantainance mode.

What is the configuration that device goes to mantainance mode to HA Mode automatically. withought reboot mantainance controller.

Pleasde help....

1 ACCEPTED SOLUTION

Accepted Solutions

HA Pairing is possible only

HA Pairing is possible only between the same type of hardware and software versions. Mismatch may result in Maintenance Mode.

Refer

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

1 REPLY

HA Pairing is possible only

HA Pairing is possible only between the same type of hardware and software versions. Mismatch may result in Maintenance Mode.

Refer

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

170
Views
0
Helpful
1
Replies
CreatePlease login to create content