Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HREAP configuraiton in Cisco 3850 switch and Cisco 5508 WLC

dear team,

 

I am trying to configure HREAP option in CIsco 3850 switch and WLC 5508. I am not able  to get the HREAP option in the advance TAB of the WLAN tab. Kindly let me know whether I can configure HREAP option in Cisco 3850 switch and Cisco WLC 5508.

 

Regards,

Jubair.S

7 REPLIES
Bronze

Hi, yes - you need to do the

Hi,

 

yes - you need to do the following:

 

Under wireless tab on the WLC, select the AP yu want to configure as H-REAP mode, then under the APs general tab. Choose AP Mode., and configure this to H-REAP mode.

 

Beware you will also need to modify the switch port that the AP is connected to must be changed to a trunkport, i.e. switchport mode trunk.

 

Here is a link for more detail.

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/71250-h-reap-design-deploy.html

 

HTH

 

Mike

New Member

dear Mike, I am using Cisco

dear Mike,

 

I am using Cisco 3850 switch to register my access point. After Joining the access point, i was checking the option int AP settting to make it as HREAP, but i am not getting that option. Please find the attached screenshot.

VIP Purple

Hi 3850/5760 (or Converged

Hi 

3850/5760 (or Converged Access) does not support H-REAP or any other modes other than LOCAL mode AP deployment

See below for WLC feature comparison

http://www.cisco.com/c/en/us/products/wireless/buyers-guide.html#~controllers

HTH

Rasika

*** Pls rate all useful responses ****

New Member

Hi Rasika,What about Cisco

Hi Rasika,

What about Cisco 5508. I am using Cisco AP 1600 and 3600 for this HREAP use. Am I able to configure HREAP in Cisco 5508 along with Cisco AP 1602 and 3600 series.

Silver

This is a good design and

This is a good design and deployment guide for H-reap in 5508 .

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81680-hreap-modes.html

New Member

Hi, As per the Cisco

Hi,

 

As per the Cisco documents, HREAP has been migrated as flex connect mode. 

 

http://www.xerunetworks.com/2012/05/cisco-5508-wlc-configuration-lab-wpa2-guest-access-flexconnect-aka-hreap/comment-page-1/#comments

 

New Member

That all depends on the

That all depends on the version of code that is running on the controller, I started off with HREAP on our 5508 because I was running a 7.0.x.x version once I moved to 7.4 HREAP was converted to flex connect...

330
Views
0
Helpful
7
Replies
CreatePlease login to create content