I'm trying to upgrade our NCS infrastructure from 1.3 to 2.0. I received an error during the upgrade that I needed to increase the number of CPU's, RAM, and disk. I was able to add the additional CPU, RAM, and disk. Going through the upgrade again, the only error I receive is about adding space to the /opt directory. I have over 300GB of memory free, after adding the additional space, so this should satisfy the requirement. When logging into the NCS ADE-OS, I do a sh disks and see that the OS has not recognized the additional space. With the backend OS being a Cisco Linux version, is there a command I have to run to get the OS to recognize the additional space? Any help would be appreciated. Thanks!
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...