Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Info to open case with cisco TAC

Hi all,

          I have ACS 4.2, I can't get it to authenticate my wireless clients. I am still getting EAP-TLS/EAP fail during HANDSHAKE. I triple checked my cert at both end and everything under advance setting tab is all good. I can use the same server to login to my cisco routers,switches and even the APs. I need to open a case with cisco TAC. What information  from the ACS SERVER i need to open the case?

Thanks,

Paul

  • Security and Network Management
2 REPLIES
Hall of Fame Super Gold

Re: Info to open case with cisco TAC

What information  from the ACS SERVER i need to open the case?

The serial number of the appliance.  Make sure your Cisco Service Contract is up-to-date.  If in doubt, contact the authorized Cisco reseller.  Alternatively, you can contact the reseller and have them raise a Cisco TAC case in your behalf.

Don't forget to rate useful posts.  Thanks.

Re: Info to open case with cisco TAC

Jean-Paul,

     You may have checked this already but have you verified that the controllers are configured in the ACS as authentication devices? If so are they setup as "Cisco Airespace"

Hope this helps... Please rate useful posts.

thanks

2045
Views
13
Helpful
2
Replies