03-12-2007 06:35 AM - edited 07-03-2021 01:46 PM
I am still investigating this issue, but here is something discovered using the WCS templates to push out a wlan config to WLC 4402 controllers.
I created a new wlan template with wpa security, etc and broadcast ssid turned off (unchecked), saved it and then applied it to my controllers.
I then opened up the web interface of one of the controllers to verify and saw the new wlan, but it had broadcast ssid enabled! I then went to each controller and discovered the same issue. I do not recall seeing any caveats for this but will check again.
Running WCS ver 4.0.96.0
wlc ver 4.0.207.0
03-19-2007 06:00 AM
I observed the same phenomena... however, with the massive number of changes I needed to address, I didn't follow up with a TAC case though...
03-20-2007 08:25 AM
I saw the same thing only we have WLC ver 4.0.206.0 with WCS 4.0.96.0. Again, I didn't report it either. My bad...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide