Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface for WLAN issue

We are replacing a WLC4402 with a WLC 5508. Both controllers are running 7.0.98 software. The WLANs we had defined on the 4402 didn't have an IP address on the WLC interface. We used and entered the VLAN it was to operate on.

When I setup the WLAN on the 5508. I created the interface with the It whined a bit on that saying no gateway or mask but it created it. When I setup the WLAN and try to assign it to the interface I get an error. Error setting the interface name. It seems like the error checking in 7.X code is preventing me from doing this. The 4402 had these interfaces and WLAN defined prior to upgrading to 7.0.98.

The VLANs the WLAN are running on are just a pipe to another network we don't manage. I have no IP to set on the interface. If I can't enter What should I use?