I have a unique problem in which I have my Cisco SE involved in trying to correct. When using an IOS based 1230 AP in one of my locations the RADIO interface will turn off (shut down) even though it appears as being up. All associatins are lost and the only way to reassociate to the AP is by restarting the AP. I have the latest code running for the Vxworks 1200 AP and this problem does not happen. I also have the IOS based 1230 AP deployed at all my other locations with zero problems. Cisco has provided me with a spectrum analyzer thinking it was some interference, but we have not seen any interference. Is anyone else having this problem? Please reply of e-mail me I would love to discuss this with you.
Hmm... I have had problems with the 802.11a (5Ghz) radio shutting down. It just says something like "DOT11-RADIO-FAILED" I believe in the logs and shows that it was down. Had the unit replaced once and the problem seemed to go away for quite awhile but did notice the radio failed again last week sometime and had to reboot again.
I thought it might be heat related since it was mounted on a "cloth" wall without the right mounting bracket and might have had the vents covered, but that's not the case now.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...