Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

iphone mobile can't access on Cisco WLC 2504

Dears,

I have one Cisco WLC 2504 with IOS version (7.0.220.0), and four SSID, one of them is "Guest SSID" and it's used for guest access,

I can login by used windows 7 , but on iPhone and windows 8 dosen't work ,

Also, I make debag on iPhone as attached file ,

 

Thanks in advance ,

 

6 REPLIES
VIP Purple

Hi,What do you mean by not

Hi,

What do you mean by not working ? Aren't you getting web login page ? Pls attach "show wlan <wlan_ID>" output to see how you configure your guest WLAN.

 

Also why you are staying on this particular code ? it is bit old. If you want to stay on 7.0.x I would suggest at least 7.0.250.0 (7.0MR5). Otherwise upcoming 7.4.130.0 (7.4MR3)

https://supportforums.cisco.com/document/12215931/74mr3-beta-availability

 

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Thanks for your reply,I mean,

Thanks for your reply,


I mean, I can't access it , and I can't establish Wifi access,


Kindly, find attached file of Show Wlan ID,


Thanks in advanced

VIP Purple

Hi 

Hi 

It seems you have WPA2/PSK set up for your guest WLAN. Try to disable the highlighted settings & check it again. Do a fresh capture of "debug client <client_mac>" for your iPhone & attach it if it still not working.(previous capture shows your phone getting IP & in RUN status)

Also post "show sysinfo" of your controller to confirm the code versions.

Local EAP Authentication......................... Enabled (Profile 'Local-Authen-Guest')
Security
   802.11 Authentication:........................ Open System
   Static WEP Keys............................... Disabled
   802.1X........................................ Disabled
   Wi-Fi Protected Access (WPA/WPA2)............. Enabled
      WPA (SSN IE)............................... Disabled
      WPA2 (RSN IE).............................. Enabled
         TKIP Cipher............................. Disabled
         AES Cipher.............................. Enabled
     Auth Key Management
         802.1x.................................. Disabled
         PSK..................................... Enabled
         CCKM.................................... Disabled
         FT(802.11r)............................. Disabled
         FT-PSK(802.11r)......................... Disabled
FT Reassociation Timeout......................... 20
FT Over-The-Air mode............................. Enabled
FT Over-The-Ds mode.............................. Enabled

Pls do not forget to rate all useful responses

 

HTH

Rasika

New Member

Thanks,Actually, WLC is

Thanks,

Actually, WLC is configured integration with active directory and M.S Radius server , (each user has connected to the SSID by used his active directory account)


Is I disable the above as you requested, it will be effected on another SSID that i used on the WLC ?

 

Regards,

VIP Purple

These are all WLAN specific

These are all WLAN specific settings & impact is should limited to that SSID.

 

HTH
Rasika

New Member

Could I change the option

Could I change the option through GUI or by command line ?


is possible , do you have any document about how to disable the above as your request ?

 

Many thanks

684
Views
0
Helpful
6
Replies
CreatePlease login to create content