You are most welcome :) Best of luck with your project, it sounds like you have alot of work ahead of you. Make sure you use the locking hasp mechanism to prevent the AP from sliding out of the bracket when mounting on the horizontal.
If you have a susupended ceiling with T-rails seperating tiles any of the solutions listed in the link sent by Rob will work.
Make sure there is not much clutter in the ceiling, it is always advisable to remove the ceiling tile and replace it with housing for AP as Chris is suggesting. This way the signal will distribute uniformly and you don't need to worry about flapping rubber duck antennas in the ceiling. You will know where the APs are located and it will look neat too.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...