Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is it possible to use a PIX to terminate a VPN from WLAN clients?

I have a WLAN with Aironet350 clients and want to establish an IPSec VPN tunnel to secure the radio communications between the wireless clients and the internal LAN.

Could I connect all as follows and have the wireless clients be able to access the resources on the internal LAN as well as the Internet?

WLAN -> AP350 -> PIX1 -> Internal LAN -> PIX2 -> ISP Router

The WLAN clients would use the Cisco VPN Client 3.6 to connect to PIX1.

Does this make any sense?

1 REPLY
Anonymous
N/A

Re: Is it possible to use a PIX to terminate a VPN from WLAN cli

This setup will work fine without any issues. I have seen a number of scenarios where PIX has been used to terminate VPN from a WLAN.

Some useful information can be found at:

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_user_guide09186a00800bd984.html

112
Views
0
Helpful
1
Replies