Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Issue Apply Dynamic Interface from Prime

Hi all,

I have some problems applying a Dynamic Interface Template from prime to my WLC:

Prime: 1.3.0.20 Update 4

WLC 5508 / 7.4.110.0

I can Apply this template to older WLC versions.

The LAG mode is enabled on my WLC.

Any Idea?

Willem

Capture.PNG

5 REPLIES
VIP Purple

Issue Apply Dynamic Interface from Prime

what is the error you are facing???

Can you paste the screenshot.

Regards

New Member

Issue Apply Dynamic Interface from Prime

If I click on "apply to controllers..." there is a list of controllers but the controller I want to apply the template to is not in this list (new controller, the first 7.4 connected to this prime, the other controllers are 4402 or 5508 all with 7.0.235.0) .

If I clear the LAG flag, there is one controller in the list but also not the one I want to apply the template to.

The controller will show up in other lists like "NTP".

I can also apply NTP Servers to this controller, what means that in general the communication is possible.

VIP Purple

Issue Apply Dynamic Interface from Prime

1. is the 7.4v controller is connected to prime infra????

2. can you check again on WLC, is LAG enabled on 5508 or not ?

Regards

New Member

Issue Apply Dynamic Interface from Prime

Hi I found it , if I scroll down the list I'll find it

I think I have to get used to the huge white screen part below the small scrollable Information part

VIP Purple

Issue Apply Dynamic Interface from Prime

Great that finally you scrolled down to check it. Same things happened with me when frist time I was configuring WLC via WCS.

Regards

Dont forget to arte helpful posts and mark the question as answered, it may help others.

182
Views
15
Helpful
5
Replies
CreatePlease to create content