LAG from N7k to 5508 getting Duplex Mismatch errors
A duplex mismatch is a situation where the switch operates at full duplex and the connected device operates at half duplex or vice versa. The results of a duplex mismatch are extremely slow performance, intermittent connectivity, and loss of connection. Other possible causes of data link errors at full duplex are bad cables, faulty switch ports, or client software or hardware issues.
Resolution : Since for 5500s WLC , data rate is fixed 1k full duplex, please check the switch side data rate , make sure it is set to 1000 Mbps Full Duplex.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...