Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Layer3&4 Access List for AP1230

Hi,

We have a 1230AP running 12.2(13)JA1 IOS.

I am trying to define a Layer3/4 ACL entry as

permit tcp any host 10.10.1.1 eq 23

However I cannot find a way doing that through the Web Interface. I can add the entry using CLI though.

However if I add this entry to an alreay configured ACL (which was configured using Web), I can no longer see it through the Web Interface.

My question is

1. Though the ACL doesn't appear in the Web Interface, Will it still apply to the actual Traffic ? (As it does appear in CLI)

2. Does the AP support these kind of Layer3&4 filters ?

Regards,

Naman

1 REPLY
Silver

Re: Layer3&4 Access List for AP1230

The problem is that there is a limitation on how long the command sent from web browser to AP can be. The command, when sent from web browser is sent in the form of a cookie and every browser will have a limit on how many cookies it can send.

Better stick with CLI while configuring the filters.

128
Views
0
Helpful
1
Replies
CreatePlease to create content