Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LEAP Authentication across multiple bridges.

Hi All,

I use Cisco Aironet 350 series to provide point to point connection of about 15 KM distance. The configuration is as follows:

CSAC Ver 3.0---HUB ----|---RootBridge(SSID 1)

|---Non-Root (SSID 2)----Root (SSID 2)---|-HUB

RootX(SSID1)--|

RootBridge has been configured for LEAP authentication and works well for all clients connecting to it. However, Clients connecting to the network through RootX cannot be authenticated eventhough all bridges have LEAP enabled.

Any suggestions?

Thanks.

Chafe

1 REPLY
Bronze

Re: LEAP Authentication across multiple bridges.

The multiple SSID feature is active only when VLANs are enabled. You can use multiple SSIDs to create different levels of network access and to access virtual LANs (VLANs). You can configure up to 16 separate SSID-to-VLAN pairs on your network. Since you have made no mention of that, do check if you have configured VLAN.

137
Views
0
Helpful
1
Replies