Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LEAP Configuration

We have ACS 3.2 appliance and Cisco Aironet 350 with version 12.00, Cisco PCMCIA card, driver ver. 8.3.10, firmware ver. 5.30.17. We have followed Cisco procedure to configure LEAP to be the authentication method. The AP has been added to ACS. When want to associate with it, connection failed. But when we use Cisco PCMCIA that manufactured for AirMagnet, associate started. Can you help me to solve this issue? By the way, the timeout is 90 sec

1 REPLY

Re: LEAP Configuration

Are you getting any diagnostics via ACS? Any failed attempts or passed authentications? (ie: is the ACS getting anything from the device?)

If not, you probably have a problem in either the configuration of your ACS or the Radius configuration on the client.

If you are, you might be able to figure out the problem from the error message given.

Otherwise, we'd need alot more info as to how everything is configured to help diagnose this any further.

614
Views
0
Helpful
1
Replies