Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Leap no longe rworks when going from IOS AP to LWAPP

we have been using LEAP for our wireless connection from laptops for sometime,the configuration is part of the Laptop SOE, so a user can go to any of our sites and connect by wireless, all our sites use standard IOS based APs, we are just setting up our first LWAPP and find the laptops will no longer connect, I see reading other posts that is most probably due to the LWAPP uses WPA for LEAP, so i suspect the only way round my problem is to have a new setup for LEAP on the LWAPP, but it means i can no longer have a single configuration for all my sites..till they have all gone to LWAPP..is my thinking correct

1 REPLY
Anonymous
N/A

Re: Leap no longe rworks when going from IOS AP to LWAPP

it could be due to Broadcast Key issue between thel LEAP client and the LWAPP architecture.

100
Views
0
Helpful
1
Replies