Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LEAP question

I’m using LEAP with a Cisco ACS and Aironet 350 access points. I have configured the ACS to change the WEP keys every 30 minutes.

I’m getting the following message periodically on the access point.

“No EAP-Authentication response for Station”.

The client eventually does authenticate and gain access to the network, but when they get this message, they loose network connectivity.

An ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: LEAP question

What version of ACS are you using? There is a known issue with ACS 2.6.x. The problem being LEAP timeouts. Users must try LEAP multiple time before a sucessful athentication.

-------------

CSCds88673: Timeout issue for Aironet client causing authentication problem

Cisco Secure ACS pauses for several seconds before replying to a Cisco Aironet Access Point authentication request. This results in the Access Point resending its authentication request.

Workaround/Solution: None. Authentications for valid requests succeed after the delay.

3 REPLIES
Community Member

Re: LEAP question

What version of ACS are you using? There is a known issue with ACS 2.6.x. The problem being LEAP timeouts. Users must try LEAP multiple time before a sucessful athentication.

-------------

CSCds88673: Timeout issue for Aironet client causing authentication problem

Cisco Secure ACS pauses for several seconds before replying to a Cisco Aironet Access Point authentication request. This results in the Access Point resending its authentication request.

Workaround/Solution: None. Authentications for valid requests succeed after the delay.

Community Member

Re: LEAP question

I was afraid of that. I am running version 2.6. I guess its time to upgrade!

Thanks for your reply!

Chris

Community Member

Re: LEAP question

Your Welcome. I hope the new deployment of ACS goes well.

Curtis R. Gregg

436
Views
0
Helpful
3
Replies
CreatePlease to create content