Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Lightweight AP Syslog Level

Does anyone out there know if there's a way to control the syslog level lightweight APs use for trap logging? I know it's possible to configure them to log to a particular host instead of the default of the 255.255.255.255 but I can't find any command or option to change the trap logging level. It apparently defaults to emergencies and I'd like to set to informational instead to capture additional log data.

Thanks,

Brandon

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: Lightweight AP Syslog Level

Below should help you to do this. If you want to do it for a AP then you need to type AP name instead of all. Also make sure APs get register to your controller before doing this.

config ap logging syslog facility   all

config ap logging syslog level informational all

config ap syslog host global

You can verify by using below commands

show ap config global

show logging

show ap config general

HTH

Rasika

3 REPLIES
VIP Purple

Re: Lightweight AP Syslog Level

Below should help you to do this. If you want to do it for a AP then you need to type AP name instead of all. Also make sure APs get register to your controller before doing this.

config ap logging syslog facility   all

config ap logging syslog level informational all

config ap syslog host global

You can verify by using below commands

show ap config global

show logging

show ap config general

HTH

Rasika

Community Member

Re: Lightweight AP Syslog Level

Yep that's what I was looking for! Thanks! Next time I'll RTM more closely

-Brandon

VIP Purple

Lightweight AP Syslog Level

Great.. Thanks for rating the response

540
Views
0
Helpful
3
Replies
CreatePlease to create content