I was working on lwapp conversion last night and ran into some issues.Out of the 24 access points (1130 series), only 2 access points will join the WiSM controllers. Interestingly enough these are the WDS access points that all others used to connect to radius. The others will keep an 180 second hold time before rebooting continously. According to cdp neighbor details, the AP's all show up with the proper recovery image but no IP address. All ports specific to these AP's have been changed to floor/switch specific vlans. Core and dist have also been updated as is done normally.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...