Not unless the location sw is available under special file access from CCO.
Otherwise you will have to get the location appliance (cisco colored ibm server running redhat ES 4+location server)
I haven't toyed with it that much, but it would not be too hard to build a redhat vm and try to pull over the location sw from a location appliance; whether it works or not is another question! But that would require that you purchase the location appliance.
You cannot install the location appliance software on a vmware server. There is a hardware check which will prevent operation in case you you try to start it up on any server other than the one acquired though Cisco.
yup yup ...no can do .. i looked into this over a year ago ..
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...