Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Location server

Folks,

I just setup a location sever. went through the setup tool and setup the hostname and ip address, etc.

When i go to WCS and try to import the location server, it using account admin/admin and trying to connect at port 8001 to the location server by default.

In my case wcs fails to connect to locatin server, what can i do to fix the problem.

6 REPLIES

Re: Location server

What version of WCS and what version of location ?

New Member

Re: Location server

WCS 3.0

and the latest version of location server.

Re: Location server

That is not compatible.

Latest version of location server (providing you mean 6.0.x) works with WCS : 6.0.132.0 or later only

Refer to the location server release notes to find a compatible version for WCS:

http://www.cisco.com/en/US/products/ps6386/prod_release_notes_list.html

WCS 3.0 (very old) works with Location 1.2.20.0, and nothing later than that.

New Member

Re: Location server

I am running the following now and I get the same error, please help.

Version 4.2.128.0 - wcs server

3.1.43.0 -location server

New Member

Re: Location server

The WCS is trying to connect to the location server using account admin/admin, and at port 8001, but can not connect with these credidentials, I can ping between the two and also can ssh into the location sever.

Re: Location server

-admin/admin are the default credentials, if you have a doubt, you want to re-run the setup from the installers folder

-Try with https instead of http and also make sure port 8001 is not blocked. Do a netstat -an on the location to make sure it's listening on those ports

-Delete and re add the location on WCS

254
Views
0
Helpful
6
Replies