Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lost Authentication with Parent) 350 Bridge Lan to Lan setup

350 Bridge

System Firmware 11.21

Radio Firmware

Lan to Lan

Right now is following security optins not set!

MIC

WEB

TKIP

the bridge switcing between those to message

Lost Authentication with Parent and

Associated to Parent [W-LI2-1]0040963a6137

and there can be about 1 to 40 seconds betwenn this message.

When i do the ping command ore doing a FTP session it making time out about 20 sekonds to 2minuts evry 3 minut.

I hope somebody can help mee

1 REPLY
New Member

Re: Lost Authentication with Parent) 350 Bridge Lan to Lan setup

From my experience with this equipment if you are getting a lost association and you are certain that the config is simple (default) and have great line of site then you are experiencing interference of some kind. Might want to tilt you antenna just a little up or down to see if that helps or change your polarity. If that doesnt help then would suggest a spectrum analyzer to see what is in the area in terms of interference. Could also try changing the Freq channel on the root radio to a different one and try that.

232
Views
8
Helpful
1
Replies
CreatePlease login to create content