LWAPP mesh point to point bridge and Nortel VRRP problems?
Are having problem with a lwapp mesh point-to-point link. The Root-AP is connected to the Nortel-based network via a Nortel switch to the Core switches (Nortel 8600). On the remote site The Mesh-AP is connected to a Nortel switch to provide LAN access to users. The Root-AP and Mesh-AP are connected via wireless (A-radio).
The Nortel Core switches are running VRRP.
When pinging from a different network IP address than the one that the APs are on (i.e. when there is routing involved) the connectivity is lost for a period of time and then comes back again and so on...
If VRRP is turned off on the Nortel core switches the problem is gone and it works fine...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...