Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LWAPP: Upgrading a 1242AG to lightweight mode

Hello,

i'm trying to upgrade a autonomous ap AP-AIR1242AG to lightweight, but evertime i start the tool the process is stopped, because the the tool can't reach the controller. The Tool recommands that i should permit Telnet, but it is allready permitted.

i can reach the management interface by ping, but anything else (web, ssh, telnet) doesnt work

the ap has the the version 12.3(7)JA1

controller (wlc 5508) 7.0.98.0

Upgrade Tool 3.4

Image 12.3(11)JX1

Can anyone  help me to solve this problem?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: LWAPP: Upgrading a 1242AG to lightweight mode

If it is a newer 1242 AP I'd just manually load the LWAPP Conversion image.

using this command

archive download-sw /force-reload /overwrite tftp:///c1240-rcvk9w8-tar.124-21a.JA2.tar

2 REPLIES

Re: LWAPP: Upgrading a 1242AG to lightweight mode

If it is a newer 1242 AP I'd just manually load the LWAPP Conversion image.

using this command

archive download-sw /force-reload /overwrite tftp:///c1240-rcvk9w8-tar.124-21a.JA2.tar

New Member

Re: LWAPP: Upgrading a 1242AG to lightweight mode

thank you, the upgrade was successful, but i cant understand why i can ping the management interface but nothuing else.

2312
Views
0
Helpful
2
Replies