Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MAC filter changes the MAC address on display

Hello,

I am setting MAC filters on my AP 1230. Althought it seem to be working, when I enter a MAC I see no errors at all but when using both the IOS or browser to see my current configuration I see different MAC addresses than the ones I type in the access-list.

Do you have any clue? please let me know if this is normal or I am missing something here.

Regards,

  • Security and Network Management
1 REPLY
Anonymous
N/A

Re: MAC filter changes the MAC address on display

Make sure that after specifying the filter, you have clicked on "Apply" Button.

Even if the filter is saved on the access point, it will not be enabled until you apply it on the"Apply Filters page".

If clients are not filtered immediately, click Reload on the System Configuration page to restart the access point.

See Step 10 in the following document:

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo1100/accsspts/i12211ja/i12211sc/s11filt.htm#91655

236
Views
0
Helpful
1
Replies
This widget could not be displayed.