12-15-2005 10:58 AM - edited 07-04-2021 11:25 AM
Hello
If I connect my access point (1130) to a switch trunk port (because I need different VLANs on different SSIDs) how can I define on which VLAN the APs IP address is?
Must it be the native VLAN? If so, where do I have to define it?
Thanks
Thomas
12-15-2005 12:43 PM
you will need to add the management ip on the native vlan via BVI1
----------
interface BVI1
ip address 172.16.10.28 255.255.255.192
no ip route-cache
do a conf t
then in bvi1
ip add xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy
where x is the IP and y is the netmask
01-21-2006 08:28 PM
When you create the multiple subinterfaces under your fastethernet config, you need to enable dot1q on the subinterfaces. Then mark your management subinterface vlan as the native vlan. Do the same for the switch port.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: