Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Managing Wireless 340s via SNMP

I have Cisco Wireless Bridge 340s (AP). How I can

add/remove Control Node Access in Association table via SNMP?

Otherwise, How I can block/unblock radiouser via SNMP?

What is OID for this action? Answer me If possible with the examples please?

This problem is very important for me!

Thanks.

Sergey.

1 REPLY
Silver

Re: Managing Wireless 340s via SNMP

Blocking/unblocking in an AP is done through MAC filters in most of the AP's. The AP will have an HTTP interface through which these filters can be created. There seems to be no SNMP support for creating such filters. Though there is a MIB for accessing the association table, this is read-only giving the list of clients that were associated.

146
Views
0
Helpful
1
Replies
CreatePlease to create content