Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Meshing Access Points to a single SSID without WLC.

Hi,

Is there a way i can do this?

I have 3 access points (1131AG and 1242AG) spread out over the floor but i want to also enable fast roaming and some sort of adjacency with secure communications.

Its hard to find anything without getting the WLC involved...

Please help!

Thanks in advance.

1 REPLY
New Member

Re: Meshing Access Points to a single SSID without WLC.

Do you need to make 2 of them mesh with a central? that would be ideal then just set the central as root mode and the other two as non-root mode, set ssid the same on all and you should be good to go. I use the 1252, the benefit being I can dedicate the 5ghz radio to the backhaul link and the 2.4 for clients.

120
Views
0
Helpful
1
Replies