Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MIB OID to get number of Wireless Clients currently associated to an AP?

Cisco 350 Series AP's, 12.0.2T1, and I've been wading through the countless MIB OID's looking for that magical one that tells me the number of client cards that are CURRENTLY associated with the AP. I'm trying to develop a "usage meter" for Management Level dashboard, i.e. "Lookie See how many devices are on our Wireless Network right now!" Any other suggestions appreciated.

3 REPLIES
Blue

Re: MIB OID to get number of Wireless Clients currently associat

Couple of objects from AWCVX-MIB that you can look at:

awcFtClientSTASelf (.1.3.6.1.4.1.522.3.12.1.8)

awcDot11TpFdbAddress (.1.3.6.1.4.1.522.3.12.5.1.1)

awcDot11TpFdbAID (.1.3.6.1.4.1.522.3.12.5.1.2)

if the AID is between 2 and 2007 inclusive, then the client is associated to the AP you are polling.

New Member

Re: MIB OID to get number of Wireless Clients currently associat

Very Helpful. The first OID mentioned gives me what I'm looking for except that it's the number of associations on the particular AP I'm polling. Is there a way to get the whole number on the "system", so I don't have to poll a hundred AP's and add their results together?

I found the OID just before this one in the same table:

awcFtClientSTA OID 1.3.6.1.4.1.522.3.12.1.7

gives me almost what I need, in that it's for the whole system, but it includes in it's count the wireless clients who were associated, but no longer are (in the UnAuth state).

Now, if only there was an object that excluded the UnAuth state clients, or one that told me how many were UnAuth so I could subtract from awcFtClientSTA????

New Member

Re: MIB OID to get number of Wireless Clients currently associat

On this topic of SNMP graphing, has anyone else graphed any other bits of information. Im currently playing with MRTG to document load, users and the like, but it would be nice to be able to do signal, noise etc per client. Anyone got any tips on how this can be achieved? Just getting the associations graph is useful in itself.

Cheers,

Greg

390
Views
0
Helpful
3
Replies
CreatePlease login to create content