We need to monitor our AIR-LAP1042N-T-K9 (using WLC AIR-CT5508-K9) to generate tickets when an AP goes down. We´ve searched MIB ciscoLwappAp (.22.214.171.124.126.96.36.199.513.1.1), and inside the cLApTable there are cLApName and cLApAdminStatus. This last one seemed to be ok at 1st but it does not because for the AP´s that are down it even has an entry in the table. At the controller the command bellow shows all the AP´s including those that are down:
(Cisco Controller) >show ap join stats summary all
Number of APs.............................................. 269
Base Mac AP EthernetMac AP Name IP Address Status 00:08:30:e4:89:90 70:81:05:78:01:cb 448-AP05 10.96.168.124 Joined 00:08:30:e4:8c:a0 70:81:05:88:09:c1 072-AP07 10.32.106.132 Joined d0:c2:82:f1:82:90 30:e4:db:44:f6:f2 296-AP04 10.136.10.100 Joined d0:c2:82:f1:83:00 30:e4:db:40:e2:df 152-AP01 10.16.90.133 Not joined <== d0:c2:82:f1:83:20 30:e4:db:44:f6:ce 398-AP04 10.128.50.123 Joined
Need help to get the correct MIB OID for this.
Using WLC AIR-CT5508-K9
Primary Softw version 188.8.131.52 Thank you. Guilherme
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...