Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Migrating data from 4404 to WiSM

Hello,

Is it possible to download configuration data created from a 4404 into a WiSM in order to migrate the configs into the blade? If not, how is the migration performed?

I'm going to be putting in a WiSM to replace my two 4404's, so any information or tips on the migration process would be appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Migrating data from 4404 to WiSM

Hi Peter,

The vale none means controller will prompt you to enter static ip address. So if you want you can enter any ip address statically also or if you choose DHCP your serive port will get an ip automatically.

HTH

Ankur

*Pls rate all helpfull post

3 REPLIES
Cisco Employee

Re: Migrating data from 4404 to WiSM

Hi Peter,

As far as WISM is concerned it is exactly 4404 controller with LAG enabled. So if you current 4404 is configured with LAG and both 4404 and WISM are running same Controller code you are good to go. I believe you just need to take care of the IPs configured on old 4404 controller if you are completely taking your 4404 out then its ok or else you have to configure new ip range either on your existing 4404 or else on WISM.

Just make sure WISM is up and running and are showing OK status when you issue "sh wism status" command on sup engine.

HTH

Ankur

*Pls rate all helpfull post

New Member

Re: Migrating data from 4404 to WiSM

Thanks, that's good news.

I do have a semi-related question that has to do with initial setup.

When running the configuration setup, according to the documentation there is a line that reads:

"Service Interface IP Address Configuration [none][DHCP]:"

Question is, does the value 'none' prompt me to enter a static address? Or do I have no choice but to use DHCP initially if i want the service-port to have an address?

Cisco Employee

Re: Migrating data from 4404 to WiSM

Hi Peter,

The vale none means controller will prompt you to enter static ip address. So if you want you can enter any ip address statically also or if you choose DHCP your serive port will get an ip automatically.

HTH

Ankur

*Pls rate all helpfull post

125
Views
5
Helpful
3
Replies