You cant. Those are your options. They are virtual floor areas and do not have to match up directly with your actual floors. At least not yet. We are trying to get Cisco to go to a 3d map rendering engine to assist in viewing interfloor bleed through issues. Then each floor would have to be completed in its entirety and stacked in the appropriate position on top of its lower floor. As it is now you could in theory split floor 2 in half to accomodate a large number of APs. Each half would have a floor identifier such as 1 or 2.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...