I've recently upgrade the wireless infrastructure to the latest versions of code. but since doing that when, i go into the monitor page for an access point in the wcs at the bottom it should show all the other access point it can see and their signal strength but now its not showings anything. i think this could be causing problems with our location applience as our tracking has gone a bit screwey. any ideas?
Currently using 1242 Lwap ap's
4404 wireless lan controllers
2700 location appliance and a wireless lan controller. all running the latest version of code.
This is a known issue documented in release notes of 5.1. This should not impact location accuracy.
CSCsr27204-Rx neighbor information is missing from the Monitor > Access Point window when you choose an active access point and click on either radio.
Workaround: The Rx neighbor and other similar information is available from the Maps page. If you hover over the access point in Maps for each radio tab, an Rx neighbor link shows the complete information.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...