Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Mobility groups, failover across different subnets

I've been reading up on 5.1 and am wondering how and if actual failover across subnets is an option.

I understand the roaming of clients from controllers in the same MG on diff subnets.

How does it work if your primary "anchor" isn't alive to replicate the DB entry to the off-subnet controller? Say if my local WIsm's die and the backup is in the next state, how will the AP's maintain connectivity?

thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Mobility groups, failover across different subnets

Yes, but tha ap's will take the new configuration from that WLC. Also... users will get tunneled back to that wlc and be dumped off in that subnet. So make sure you understand the ssid and what ip's clients will get when they associate to different wlc's. That should do it.

-Scott
*** Please rate helpful posts ***
3 REPLIES
Hall of Fame Super Silver

Re: Mobility groups, failover across different subnets

If the primary wlc dies, the ap's will have to move to the secondary or tertiary wlc. This will cause a loss of network connectivity so the users will have to reassociate and obtain a new ip.

-Scott
*** Please rate helpful posts ***
New Member

Re: Mobility groups, failover across different subnets

thanks fella. So that means that my AP's configured w/ static IPs will work fine once they find the backup controller on the diff subnet?

Hall of Fame Super Silver

Re: Mobility groups, failover across different subnets

Yes, but tha ap's will take the new configuration from that WLC. Also... users will get tunneled back to that wlc and be dumped off in that subnet. So make sure you understand the ssid and what ip's clients will get when they associate to different wlc's. That should do it.

-Scott
*** Please rate helpful posts ***
205
Views
0
Helpful
3
Replies
CreatePlease to create content