Ok we have a mac-access list that is set and we want it only set on a specific ssid but it does not seem to be working that way and is hitting both ssid's. The issue appears to be with this line as it is not defined to the ssid nor any interface for that ssid:
dot11 association mac-list 701
I just can't figure out where to move it and how. Any help would be great.
Here is my config:
BER-AP18#show running-config Building configuration...
Current configuration : 11695 bytes ! ! Last configuration change at 11:04:00 EDT Wed Jun 6 2012 by WirelessAdmin ! NVRAM config last updated at 11:04:00 EDT Wed Jun 6 2012 by WirelessAdmin ! version 12.3 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname BER-AP18 ! enable secret 5 SECRET
! clock timezone EST -5 clock summer-time EDT recurring ip subnet-zero ip domain name domain.com ip name-server 10.0.36.73 ip name-server 10.0.36.38 ! ! aaa new-model ! ! aaa group server radius rad_eap ! aaa group server radius rad_mac ! aaa group server radius rad_acct ! aaa group server radius rad_admin ! aaa group server tacacs+ tac_admin ! aaa group server radius rad_pmip ! aaa group server radius dummy ! aaa authentication login eap_methods group rad_eap aaa authentication login mac_methods local aaa authorization exec default local aaa accounting network acct_methods start-stop group rad_acct aaa session-id common dot11 association mac-list 701 dot11 vlan-name Wireless vlan 22 ! dot11 ssid SWLAN vlan 36 authentication open mac-address mac_methods ! dot11 ssid WSLAN vlan 22 authentication open authentication key-management wpa guest-mode wpa-psk ascii 7 SECRET ! crypto pki trustpoint TP-self-signed-689020510 enrollment selfsigned subject-name cn=IOS-Self-Signed-Certificate-689020510 revocation-check none rsakeypair TP-self-signed-689020510 ! ! username WirelessAdmin privilege 15 password 7 SECRET
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...