09-19-2013 08:18 AM - edited 07-04-2021 12:53 AM
On our wireless network we have two 6509-E switches each with a WiSM and a 5508 WLC. The 5508 WLC only had one port connected to one of the 6509 units then we added another port on the 5508 to the other 6509. Do I need to add the IP and MAC address of the the second port of the 5508 to the existing Mobility Group?
Thanks for any help.
Jeff
09-20-2013 05:45 AM
Link-1
http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70mint.html
Link-2
09-20-2013 05:55 AM
Ageel,
Thanks for the reply but the first link I reviewed and didn't answer my question and the second link isn't working.
Jeff
09-21-2013 08:24 AM
You only can attach the other port to the other chassis if your WLC is doing lag and the chassis is setup for vss. You can do this also if you don't have lag, but you have to define the WLC interface as which is primary and which is backup.
Sent from Cisco Technical Support iPad App
09-22-2013 12:42 PM
When you adding mobility member you need to configure the Controller IP address & its MAC address (NOT the interface MAC address WLC connect to). Therefore in any connection type (LAG enabled or NOT) it has to be your 5508 controller IP address & its own MAC address.
If you type "show sysinfo" or "show mobility summary" on your 5508 you can get this information as shown below. Then you can add that onto your exisiting mobility group configuration of WiSM (you have to add WiSM detail on your 5508 mobility config as well)
(5508) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 7.5.102.0
System Name...................................... 5508
IP Address....................................... 10.10.10.10
Burned-in MAC Address............................ 64:00:F1:F5:B0:80
Power Supply 1................................... Present, OK
Power Supply 2................................... Present, OK
(5508) >show mobility summary
Mobility Protocol Port........................... 16666
Default Mobility Domain.......................... dmz
Multicast Mode .................................. Disabled
Mobility Domain ID for 802.11r................... 0xe49d
Mobility Keepalive Interval...................... 10
Mobility Keepalive Count......................... 3
Mobility Group Members Configured................ 9
Mobility Control Message DSCP Value.............. 0
Controllers configured in the Mobility Group
MAC Address IP Address Group Name Multicast IP Status
64:00:f1:f5:b0:80 10.10.10.10 dmz 0.0.0.0
HTH
Rasika
***** Pls rate all useful responses ****
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: