I would like to have a guest Web auth based WLAN that points to an Interface that I also have configured for a separate 802.1X authentication that allows access to my private network. I should note that I already have web auth configured for Guest access that only allows Internet access via separate WALN/VLAN. This would allow me to setup access for a vendor that is on-site using the Lobby Ambassador .
Is this possible and what do I need to do? I have created the seperate WLAN with Web auth and pointed it to the same WLC interface that I use for the 802.1X and this does not seem to work.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...