MX64 - default gateway

[CotGef]

Hello,

i installed a Meraki MX64 in a network, using the router as DHCP server. I've seen that i need to manually specify the MX64 as the default gateway on every device to make them access the network.

Letting the computers automatically obtain the gateway address does not work.

Is there a way to let them get the correct address as default gateway?

Thank you

[Flavio Miranda]

@CotGef

Default Gateway should be on the DHCP response from the DHCP server. Dont make sense put this information on each device.

 Who is providing DHCP service ? 

If you are using thirty part DHCP service, Meraki should be configured as DHCP relay:

1. Navigate to Security appliance > Configure > DHCP
2. Locate the subnet in the list that should have DHCP relay enabled.
3. For 'Client addressing', change the drop-down menu to 'Relay DHCP to another server'.
4. In the 'DHCP server IP' box that appears, enter the IP address of the DHCP server that should serve this subnet.
5. At the bottom of the page, click 'Save Changes'.

-If I helped you somehow, please, rate it as useful.-