I've setup a WLSE to auto-configure a new AP (set opts 66 & 67 in the DHCP server) so that the WLSE detects and manages a new AP when it's first powered on. The only thing I haven't managed to make it do is assign a unique name and the correct ststic IP address to the AP's, I have to do this part manually.
Is there any way this can be built into the WLSE templates?
Since the templates are designed for mass deployment there is not a value for hostname and IP address under the predefined options. You can define a template for a specific device and enter these commands in the custom values. Remember that the custom values are not validated by wlse and syntax is not checked.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...