03-07-2012 09:36 AM - edited 07-03-2021 09:44 PM
Question,
This is going to end up being really dumb, I can just feel it. So, we demo'd a 3500 with CleanAir before working with Cisco and purchasing a first batch. The demo worked as expected, just plugged it in and it went to town serving clients and reporting on it's channel in local mode, no problem. My first batch I have two AP's, 3502i's to be exact, plugged in and running on my 5508 with 7.0.98.0 code and and NCS Demo. The AP is up and serving in local mode, however NCS says
CleanAir Management Operation State |
|
I took a look at the WLC and it says:
CleanAir
Oper
Status DOWN
So, why.. and where do I put it UP.
BTW, this AP is connected to a 3750x stack, shouldn't be an issue there...
Solved! Go to Solution.
03-07-2012 09:42 AM
Look under the network setting in 802.11an and 802.11bgn. There is a CleanAir link... Make sure it is enabled there.
Thanks,
Scott Fella
Sent from my iPhone
03-07-2012 09:42 AM
Look under the network setting in 802.11an and 802.11bgn. There is a CleanAir link... Make sure it is enabled there.
Thanks,
Scott Fella
Sent from my iPhone
03-07-2012 09:57 AM
*&@&, i knew it was dumb. completely forgot about it, knew it had to be a setting somewhere there. Thanks Scott.
03-07-2012 09:59 AM
Haha… that is funny though☺
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: