This is going to end up being really dumb, I can just feel it. So, we demo'd a 3500 with CleanAir before working with Cisco and purchasing a first batch. The demo worked as expected, just plugged it in and it went to town serving clients and reporting on it's channel in local mode, no problem. My first batch I have two AP's, 3502i's to be exact, plugged in and running on my 5508 with 126.96.36.199 code and and NCS Demo. The AP is up and serving in local mode, however NCS says
CleanAir Management Operation State
I took a look at the WLC and it says:
So, why.. and where do I put it UP.
BTW, this AP is connected to a 3750x stack, shouldn't be an issue there...
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...