NCS associated with controller problem.

[Ahmed Ayaad]

Dears,

HI

I have PI 1.3  deployed  on ESXI 4 (in HP Blade)  with ip 192.168.220.230 after that i deployed virtual controller on the same blade with ip 192.168.220.232 the HP Blade connected to multilayer switch and i can ping from the NCS to Controller but when i try to add the controller on NCS i see the following error"Add Device Failed! Device already exists in the current domain"), how i can solve this problem,

Knowing that i configure on the controller the Community Name, IP address 192.168.220.230, Ip mask 192.168.220.232 ,Access mode ReadWrite, and status enabled.

Also configured Interface vlan(192.168.220.1) and the Blade access this vlan.

Thanks,

[Scott Fella]

Might want to look at this link.

https://supportforums.cisco.com/docs/DOC-27761

Sent from Cisco Technical Support iPhone App

[Sandeep Choudhary]

adding to scott...

Check under Configure - Unknown Devices

Regards