Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NCS associated with controller problem.

Dears,

HI

I have PI 1.3  deployed  on ESXI 4 (in HP Blade)  with ip 192.168.220.230 after that i deployed virtual controller on the same blade with ip 192.168.220.232 the HP Blade connected to multilayer switch and i can ping from the NCS to Controller but when i try to add the controller on NCS i see the following error"Add Device Failed! Device already exists in the current domain"), how i can solve this problem,

Knowing that i configure on the controller the Community Name, IP address 192.168.220.230, Ip mask 192.168.220.232 ,Access mode ReadWrite, and status enabled.

Also configured Interface vlan(192.168.220.1) and the Blade access this vlan.

Thanks,

2 REPLIES
Hall of Fame Super Silver

Re: NCS associated with controller problem.

Might want to look at this link.

https://supportforums.cisco.com/docs/DOC-27761

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Purple

NCS associated with controller problem.

adding to scott...

Check under Configure - Unknown Devices

Regards

170
Views
0
Helpful
2
Replies