Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

NCS High Availability, Database does not sync

Hi All, i have a setup with NCS 1.1 in a HA Environment. The initial Syncing tooks Place. Since then i added Templates, Maps and so on. Now i tested Failover. The Server comes up, logging in possible. Controllers and AP are available, but no Configuration Template or Campus or  Map. As the NCS Config Guide promised, syncing should be done automatically. Is there a way to check the synchronisation or have i something forgotten to deploy? Any Hint or Experience?

TiA, Michael

Everyone's tags (1)
2 REPLIES

Re: NCS High Availability, Database does not sync

Mike:

I don't think that templates are being copied! as per the guide:

The following files are copied over from the primary to the secondary NCS:

•DB password file

•all auto provisioning startup config files

•all domain maps

•all history reports which are generated by scheduled report tasks

Reference: http://www.cisco.com/en/US/docs/wireless/ncs/1.0/configuration/guide/admin.html#wp1178663

Rating useful replies is more useful than saying "Thank you"
New Member

NCS High Availability, Database does not sync

Hi Amjad, thx for your Answer. I dont worry much about Templates, my sorrow is to loose the Maps. I have 2 Campusses with around 20 Buildings, up to 6 Floors in each of them, nearby 1000 APs. Its a Lot of Work to rebuild all this if i loose my Primary NCS and the Secondary one will not be in sync and all Maps are gone.

No Idea anyone?

BR, Michael

390
Views
5
Helpful
2
Replies
CreatePlease to create content