Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NCS Prime prompting for login and password after re-imaging from dvd

Dear All,

 

I did a re-imaging on NCS prime after which I'm getting the below error

Please help me as to what could be the reason for this error...

**********************************************
Please type 'setup' to configure the appliance
**********************************************
localhost.localdomain login: Setup
Password: 

 

 

Regards,

Waseq Mohammed

2 REPLIES

Follow the process from

Follow the process from here

http://www.cisco.com/c/en/us/td/docs/wireless/ncs/appliance/install/guide/primencs_qsg/primencs_qsgmain.html

Cisco Employee

Re-imaging was not successful

Re-imaging was not successful try this process:

Restoring the NCS Database

If you are restoring the NCS database in a high availability environment, see the "Restoring the NCS Database in a High Availability Environment" section. To restore the NCS database from a backup file. follow these steps:


Step 1 To view all local repository backups, use the below command:

show repository backup_repo


Note If possible, stop all NCS user interfaces to stabilize the database.


Step 2 Manually shutdown the platform as root.

Step 3 Using the CLI, perform one of the following:

Restore the appliance and application backup by entering the following command:

restore testbackup-yymmdd-xxxx.tar.gpg repository backup_repo

Restore only the application backup by entering the following command:

restore testbackup-yymmdd-xxxx.tar.gpg repository backup_repo application NCS

Step 4 Click Yes if a message appears indicating that NCS is running and needs to be shut down.


Note If the restore process shuts down NCS, a restart is attempted after a successful restore. The appliance will then restart and you will have to again login and restart the dbserver, and the platform manually as root (make sure you do not start with dbclean, else you will loose your recently restored data).


The CLI displays messages indicating that the NCS database is being restored.

44
Views
0
Helpful
2
Replies
CreatePlease login to create content