02-12-2014 03:33 AM - edited 07-05-2021 12:10 AM
Hi,
Im currently migrating 2,400 APs to change controller addressing.
Id like to know is their a report on NCS i can run that will show me the AP config for Pri/Sec/Ter controller config
We are running 1.3 (1.3.0.20)
Ive had a look around but not found what i wanted, id like this information to know which templates need applying to which APs
many thanks
S
02-12-2014 04:35 AM
Hi Si,
I never seen a template like this, may be someone else know or ever used this....
Why you want to change the ip of WLC at AP.
If you will change the IP of wlc at switch or ...other place (from where AP learn the ip address of WLC).
Just change the ip of wlc at that place, AP will learn automaticall if they are in correct vlan.
Regards
Dont forget to rate helpful posts
02-12-2014 08:54 AM
Hi ,
Thanks for the response. Our ap's have had the wlc IP pushed via a template. I'd like to make sure all ap's have the same wlc as it's primary after the IP address change
just hoped their was some way of auditing this config
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: