We set up our wireless network using 1200 Series AP, ACS 3.3 and WLSE 2.11 and I thought everything was working fine.
However, I just found out y'day that some new users couldnot get connected and digging further, I realised that all users need to be a member of 'Dial-In users' in Active Directory in order to access corporate network through wireless.
Why does this happen?.. is there a work around for this problem?.
Thanks for your reply. If I uncheck dial in permission, will it affect any other services, like VPN authentication or Telent authentication to router?. We use this ACS for VPN authentication for employees with VPN Access and Telnet authentication for Network Admins.
I have a similar situation. Our radius points to windows 2000 domain controllers which have microsoft's IAS service installed. I more or less inherited this setup, and who ever installed it only has one policy within IAS which says "allow access if dial-in permission is enabled".
I have been thinking about trying to make some new policies since there are many parameters available such as checking the calling nas station IP. Do you know if the IAS service is installed on your domain or domains ? If you do have IAS, you can look at the help facility within IAS and it explains the logic of how policies are applied. I have not tried this yet, but it looks as if the policies are flexible enough.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...