Can you help me to resolve my problem? I’ve 3 Cisco 4410n, they were configured as AP only. Yesterday, many users complained that accessing to internet very slow, I tried to replace this AP by other (Linksys WGH54G) and resolved this problem. I also tried upgrade to new firmware for 4410n (current 184.108.40.206 è upgrade to 220.127.116.11) but it cannot help after that I had changed wireless mode to B/G-mixed and resolved this problem. I think this is temporary solution because user cannot access internet with N mode which made me buy this AP. Waiting for your support.
if you configured your access points as repeater, that configuration will divide off the half of your bandwidth, also you need to take on mind all the devices will share the bandwidth with all your topology.
Below is a document with some advices to improve your wireless connection; you can see this in the link bellow.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...