Need to use public ip address for management on 1200ap
Our shop has numerous clients on the same equipment. Our strategy is the use of public addresses assigned to customer network to prevent rfc1918 issues. We do not use nat. I would like to use a configured loopback address as the mgmt interface. I was sent a snippet only explaining how Cisco TAC advises against the use of loopback address in AP's. Ok, but I need to get more info and whether there is a specific syntax to ensure it doesnt mess with the radio???
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...