NNM Openview - can the alarm pick up the interface description
I`m using NNM 7.5 and was wondering if there was a way you can configure the alarms to pick up the interface description and then send this via email. i`m using blat to do the email bit. i even use the variable $* but this doesnt give me the interface description. i`d be gratfeul for any advise
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...